NCL OMNISTIK- TE 106 TILE ADHESIVE, Grade: Type 1, Grey

91 000 74051 NCL OMNISTIK TE-106 is a cement-based, polymer-modified, single-component thin-bed tile adhesive from NCL Buildtek. It comes as a dry-powder blend — you just add the recommended amount of water at site, mix, and apply. No need for traditional cement-sand mixes. It's designed for both floor and wall tiling, and supports a wider variety of tiles including ceramic, vitrified, and some stone tiles. �� Typical Technical Specs (based on NCL product standards) ParameterSpecification / Benefit Tile Types Supported Ceramic, vitrified tiles; medium-weight natural stones (check tile weight) Suitable Areas Interior & exterior walls & floors (except continuously wet outdoor zones) Bed Thickness 3 mm – 10 mm depending on tile size & substrate Open Time ≥ 20 minutes — allows adjustments after placing tiles Pot Life / Working Time ~ 90–120 minutes after mixing (varies with temperature) Time to Light Traffic ~ 24 hours (may vary — follow NCL directions) Coverage Approx. 3–4 sq.ft per kg (varies with trowel size & tile type) Packaging Commonly available in 20 kg bags Bond Strength Meets Indian standards for polymer-modified thin bed adhesives Conformance Built to match performance standards similar to IS 15477 (Type 1 & T grade performance) Note: Exact numbers may slightly vary depending on batch — always check the batch label or official TE-106 datasheet before use. ✅ Where & When to Use OMNISTIK TE-106 Best uses: ✔ Standard-size ceramic or vitrified tiles on walls & floors ✔ Interior living spaces, balconies, kitchens, bathrooms ✔ Residential and light commercial applications ✔ New constructions and renovation jobs ✔ Situations needing fast and consistent bonding without manual mortar mixing Especially good because: It's easy to mix / ready to use — saves labor and time on site Gives consistent strength, reduced chances of hollow spots, and good adhesion Works on multiple substrates like concrete, plaster, screed, etc. ⚠️ What to Check / When to Use Carefully Ensure the substrate is clean, level, stable, and free of dust/oil/loose particles. Avoid use in continuously wet environments or heavy water exposure areas (like outdoor pool edges) unless paired with proper waterproofing. For very large or very heavy stone tiles (marble/granite/slabs) — consider a stronger/high-flex adhesive (e.g., NCL Cerostik TI-103, Tilostik TE-105, or NCL Platinum-grade adhesives). Follow proper trowel notch size and full-bed application to eliminate voids under tiles.